19 results are shown.
Press the device against the object to be tested. When the safety button is pressed, press the red and black button simultaneously. The tilt indicator in the display now lights up green and the REL symbol appears in the upper…
The needle wear depends on several factors. You will find an illustration of this in the maintenance instructions (page 14) enclosed with your machine.
A drill chuck should be replaced when irregular resistance is felt when turning by hand, or the rear “offset value” is over 400. (see illustration)
Control Panel > General > Rotate Display: NO Now the rotation mode of the display is switched off.
The Bluetooth must be turned on. And the correct mode must be selected for your device pairing. If there is still no connection, try out to update your Bluetooth driver. Instructions can be found under Instruction manuals & software downloads in the…
– Active Bluetooth mode means the pairing is started by the drill. You must create a new connection in order to pair. To do this, you must find the computer on the side of the device and pair it. –…
This activates the automatic needle retraction. This is a protective mechanism that counteracts excessive bending of the needle. It is set to 5 cm by default. The retraction length can be adjusted under Control Panel > Automatic Needle Retraction. !…
The test disk may be worn out. The test disc is a replaceable disc in the front adapter. If the needle is pulled through the test disc during the needle test, the needle is rated as bad. It is possible…
A test disc is worn out when the needle is assessed with the needle status “Worn out, replace needle!”. Wear marks/indentations are safe indications for a worn out test disc.
