15. November 2021
When is a test disc worn out?
A test disc is worn out when the needle is assessed with the needle status “Worn out, replace needle!”. Wear marks/indentations are safe indications for a worn out test disc.
15. November 2021
Can additional modules also be installed on the unit at a later date?
All additional modules can also be retrofitted to your device. Either at our service centre or conveniently at your home with an activation code generated by us.
21. September 2021
How can I record the measurement results? What are the data output options?
With the F-Series drill the measurements are recorded on a wax paper strip. Typically users scan the wax paper strip into their report reinforcing their assessment of the wood. The PD-Series drill records the measurements automatically in digital form and…
21. September 2021
What are the available drilling depths?
The PD- and F-Series are available in different versions. The MD-Series is only available in one drilling depth. IML-RESI PowerDrill-Series: 200mm – 1000mm IML-RESI F-Series: 300mm – 500mm IML-RESI MD-Series: 300m
21. September 2021
Can the information collected from the inspection be exported to other operating systems?
Yes, you can take the information from PD/F Tools or WoodInspector and utilize it in your GIS or other related software.
21. September 2021
How does the WoodInspector software work for pole inspections?
With the WoodInspector- software you will get a direct condition assessment of the wooden pole right after performing the measurements. Here, individually specified rot and cavity limit values of the timber branch to be inspected are included as criteria for…
21. September 2021
How can you use the drill for a pole inspection?
Many customers use the drill for pole inspections by conducting three drillings on the pole. First to determine the diameter for the WoodInspector software, second drilling into the base of the pole at an angle of about 30 degrees and…
21. September 2021
How can you use the drill for a tree inspection?
Our wood inspection drills are commonly used as a reinforcement for the VTA for tree inspections. The resistance drill is a favorite for arborists and tree specialists because it provides data on the internal state of the wood. A tree…
21. September 2021
Why do the drills need the annual calibration?
Since the drills are measuring devices we recommend an annual calibration to confirm that you are receiving accurate inspection readings. The calibration machine checks to see if the motor is still rotating at the correct revolutions per minute and the…
